Led And Symbol Indications; Definitions Of Indicators In The Display; Pointgard 2100 Ec-Specific; Control Panel - Dräger PointGard 2000 Series Gebrauchsanweisung

|
en Operation
7.2

LED and symbol indications

Symbol LED
Red
Yellow
Green
LED status
– When the first alarm (pre alarm) has been triggered the
red LED flashes in single mode
– When the second alarm (main alarm) has been triggered
the red LED flashes in double mode
– When an alarm is acknowledged before the alarm
condition clears, the red LED is lit continuously to indicate
the present alarm condition.
7.3 Definitions of indicators in the
display
Symbol Explanation
Error message available.
Warning message available.
Maintenance signal is transmitted.
Measuring range of analog interface
exceeded.
Measurement less than range of analog
interface.
Analog interface is set to a fixed value and
is not transmitting any measurement sig-
nal.
SIL SIL is activated. The instrument is not SIL-
certified. SIL functions are therefore not
supported, however the symbol can
appear.

7.3.1 PointGard 2100 EC-specific:

Symbol Explanation
"Preventive" maintenance: The sensor is
ready for operation.
"Preventive" maintenance: The sensor is
ready for operation but is close to the end
of its life cycle.
"Preventive" maintenance: The sensor is
still ready for operation but should be
changed as soon as possible.
16
Description
Alarm Triggered
Fault
Power on
.
.
Symbol Explanation
The data-logger is active in Roll mode.
The data-logger is active in stack mode.
7.4

Control panel

Button Function

Upwards / Function key
Downwards / Menu key
M
Different functions depending on the type of menu
OK
7.5

Info mode and function key

7.5.1 Activating info mode

The Info mode is used to show instrument relevant
information. This does not interrupt the normal operation of
the instrument.
● Tap and hold for 3 seconds in measuring mode.

7.5.2 Info mode navigation

Button Function
Switches to the next screen
Switches to the previous screen
M
Ends info mode
OK
If no key is tapped within 30 seconds, the instrument will
automatically return to normal operation.

7.5.3 Using function key

Using the function key, a pre-set function can be executed. By
default the faults are displayed.
● Tap and hold for 1 seconds in measuring mode.
To configure the function key, see 11.7 Configuring function
key.
7.6

Menu

7.6.1 Menu navigation

Button Function
Scrolls upwards.
Sets values.
Scrolls downwards.
M
Sets values.
Confirms entry.
OK
Selects menus and functions.
Instructions for use |
Dräger PointGard 2000 Series