6.2 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Unpack the sunshield of the device, taking
care not to damage the housing.
6.2.1 Removal of the protective
packaging
Remove the protective packaging before installing
the device.
6.2.1.1 How to open the housing
On removing the upper section of the
housing, accompany it until the anchoring
cable is taut. Do not drop the upper section
of the housing as this could cause the cable
to snap.
To open the housing, undo the screws on the sides
and lift the upper body.
Fig. 4
After installation and wiring, close the
product again.
10
6.2.1.2 Remove the protective packaging
Open the housing and remove the protective
packaging.
Fig. 5
MNVCUPKPLUS_1514_EN