Installing External Speaker - Motorola MTM800 FuG ET Installationshandbuch

Caution:
DO NOT use the 10-pin TELCO connector of Data Expansion Head Enhanced or Remote Head Enhanced to plug
in a microphone.
3 Plug the power cable into the radio power connector.
Note:
Motorola supplies a wide range of antennas and associated coaxial cables correctly terminated for use
with the mobile radio. However should the need arise to carry out reinstallation or repair of a cable or
connector then suitable information on selection and installation of replacement connectors and cables
can be found on most recognized connector and cable manufacturers, for example Radiall, Huber and
Suhner, Samtec.
The BNC Connector should be typically of the crimped variety, likewise the SMA, or FME Connector
used for GPS should also be of the crimped variety. Coaxial cable should be screened and low loss, see
the individual specification sheets for the antennas to find details of specific cable types and or
connectors. Additionally see the TETRA Interface Specification for the mobile radios for further
information.

Installing External Speaker

Procedure:
1 Remove the speaker from the trunnion bracket by loosening the two wing screws.
2 Choose a place to mount the speaker. When mounting the trunnion on the transmission hump, be careful that the
transmission housing is not affected.
3 Use the trunnion bracket as a template to mark the positions of the mounting holes.
4 Centre-punch the spots you marked and drill a 4 mm (5/32-inch) diameter hole at each location.
External Equipment Installation | 111
68015000584-J | | Send Feedback