Motorola MTM800 FuG ET Installationshandbuch Seite 53

Number Item
dio Amplifier which supplies this output requires an independent DC Supply, refer to 2
above. The use of connector kit PMLN6487_ allows a plug and play installation of the associ-
ated Loudspeakers such as RSN4002_.
4 Free-end Wires. If used during installation, heat-shrink wrap unused wires to prevent short-
ing. These connections correspond to P3 detailed in
on page
phone (HF1 and HF2) these two inputs are individually screened and include a common
drain-Ground, PTT1 and PTT2, Power On, Rear Audio and the available GPIO lines. The use
of Impres Visor Microphone RMN5054_ also requires the One Wire bus connection provided
on this cable.
5 Rear GCAI Connector. These connections correspond to P2 detailed in
Cable Pin Diagram on page 103
tor which enables compatible Accessories such as the RMN5107_ Fist Microphone to be con-
nected to the rear of the Control Head.
6 Ferrite Clamp, PN 91012044002. Manual installation is required. Clamps are installed with 2-
turns of wire around the clamp.
7 Ferrite Clamp, PN 91012044003. Manual installation is required. Clamps are installed with 2-
turns of wire around the clamp.
8 Fuse of 2A, PN 65012023001
9 Label for Y-cable power rating
Note:
See the Appendix for wiring and pin out information.
Manual installation required. Clamps are fixed with 2-turns of wire.
The Accessories Expansion TSCH Y-Cable (PMKN4134_) allows to connect extra accessories.
103. These connections provide multiple functions including Hands Free Micro-
and this is the Ten (10) pin Rear GCAI Accessory connec-
Radio Installation | 53
Figure 68: RECH Y-Cable Pin Diagram
Figure 68: RECH Y-
68015000584-J | | Send Feedback