Motorola MTM800 FuG ET Installationshandbuch Seite 98

98 | Connectors and PIN Assignment
Pin Function
4 GPIO_3
5 VBUS_1B
6 REAR_D -
7 REAR_D +
8 GPIO_0
9 EXT_PWR_12V
10 1_Wire
11 MIC_HF1_GND
12 MIC_HF1
13 GND
14 GPIO_5
15 GPIO_7
16 1_WIRE
17 REAR_AUDIO
18 GND
19 MIC_MMP_REAR
20 GPIO_4
21 SPK +
22 SPK –
Send Feedback | | 68015000584-J
Description
GCAI PIN 2 GPIO
+5 V Supply,
Connected to Pin 6 of Mobile Microphone Port
Rear handset D+ line
Rear handset D- line
GCAI Pin 10 GPIO
External power supply,
12V or 24V for External Speaker
®
1-wire bi-directional serial bus,
Connected to GCAI Pin 1 of Mobile Microphone Port
Ground for external microphone MIC_HF_1
External microphone input (MIC_HF1),
Nominal sensitivity: 80mV rms, Bias voltage: 9.3V or 2.1V
(Selected accessory dependent)
GND Common Ground
Control Head GPIO1 (CPS configured/enabled)
4 Level Analogue Input, 33k to 5.0V PU
®
1-wire bi-directional serial bus,
dedicated to power-up detection of IMPRES Visor Mic (in-
put MIC_HF1)
Handset VOL controlled audio output,
Min RL = 150 Ohm unbalanced,
Connected to GCAI Pin 3 Mobile Microphone Port Connec-
tor
GND,
Connected to GCAI Pin 5 Mobile Microphone Port
Rear microphone input MIC_MMP_REAR,
Input 80mV rms, Bias voltage 7.7V,
Connected to GCAI Pin 7 Mobile Microphone Port
GPIO, Hook Input,
Connected to GCAI Pin 9 Mobile Microphone Port.
Speaker positive line
Warning: Do not ground!
Speaker negative line
Table continued...