Motorola MTM800 FuG ET Installationshandbuch Seite 64

64 | Radio Installation
10 Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps into place.
11 Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount Enhanced Control
Head for an optimum view of the display. Then, complete the tightening of the screws.
12 There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of allowable movement, as
shown in the following picture.
Figure 33: Upward Movement
Figure 34: Downward Movement
Send Feedback | | 68015000584-J