Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise Seite 9

Do not position your body in the
¢
area where power tool will move
if kickback occurs. Kickback will propel
the tool in direction opposite to the wheel's
movement at the point of snagging.
Use special care when working
¢
corners, sharp edges etc. Avoid
bouncing and snagging the
accessory. Corners, sharp edges or
bouncing have a tendency to snag the
rotating accessory and cause loss of control
or kickback.
Do not attach a saw chain
¢
woodcarving blade or toothed saw
blade. Such blades create frequent kickback
and loss of control.
Additional safety instructions for
grinding - Safety warnings specific for
grinding
Use only wheel types that are
1.
recommended for your power tool
and the specific guard designed for
the selected wheel. Wheels for which
the power tool was not designed cannot be
adequately guarded and are unsafe.
The grinding surface of centre
2.
depressed wheels must be mounted
below the plane of the guard lip.
An improperly mounted wheel that projects
through the plane of the guard lip cannot be
adequately protected.
The guard must be securely attached
3.
to the power tool and positioned
for maximum safety, so the least
amount of wheel is exposed towards
the operator. The guard helps to protect
the operator from broken wheel fragments,
accidental contact with wheel and sparks that
could ignite clothing.
Wheels must be used only for
4.
recommended applications. For
example: do not grind with the side
of cut-off wheel. Abrasive cut-off wheels
are intended for peripheral grinding, side
forces applied to these wheels may cause
them to shatter.
Always use undamaged wheel
5.
flanges that are of correct size and
shape for your selected wheel.
Proper wheel flanges support the wheel thus
reducing the possibility of wheel breakage.
Flanges for cut-off wheels may be different
from grinding wheel flanges.
Do not use worn down wheels from
6.
larger power tools. Wheel intended for
larger power tool is not suitable for the higher
speed of a smaller tool and may burst.
Additional safety instructions for wire
brushing operations - Safety warnings
specific for wire brushing operations:
Be aware that wire bristles are
1.
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
If the use of a guard is recommended
2.
for wire brushing, do not allow any
interference of the wire wheel or
brush with the guard. Wire wheel or
brush may expand in diameter due to work
load and centrifugal forces.
Additional angle grinder warnings
Only use grinding discs where the indicated
¢
rotational speed is at least as high as what
has been specified on the name plate of the
product.
Carry out a visual inspection of the grinding
¢
disc before use. Do not use any damaged or
deformed discs. Replace any damaged or
worn discs.
Make sure that the sparks produced by
¢
grinding do not present a danger, e.g. reach
people or ignite flammable substances.
Always wear safety goggles, safety gloves,
¢
respiratory protection and ear protection
when grinding.
Never keep the fingers between the disc and
¢
spark protection or in close proximity to the
protective hoods. There is a risk of crushing.
The rotating parts of the product cannot be
¢
covered due to functional reasons. Therefore,
proceed cautiously and hold the workpiece
firmly in order to avoid slipping which could
cause your hands to come into contact with
the disc.
The workpiece gets hot during grinding.
¢
Do not touch the machined area, allow it to
cool down. There is a risk of burning. Do not
use coolants or the like.
Do not work with the product, if you are tired
¢
or have consumed alcohol or tablets. Always
have a break on time.
Turn off the product and, before doing any
¢
servicing, remove the battery pack.
GB / CY 11