Maintenance; Repair; Storage; Transportation - Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Maintenance

Q
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see "Technical data").

Repair

Q
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.

Storage

Q
Switch the product off and remove the battery
o
pack .
4
Clean the product as described above.
o
Store the product and its accessories in a
o
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
o
inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
We recommend using the original package for
o
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
Regularly check the charge level of the
o
battery pack, if it is to be stored for an
extended period. Optimum storage conditions
are cool and dry.
Grinding discs must be dry and stored
o
upright, and should never be stacked.

Transportation

Q
Switch the product off and remove the battery
o
pack 4 .
Attach transportation guards, if applicable.
o
Always carry the product by its handles.
o
Protect the product from any heavy impact
o
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
o
or falling over.

Troubleshooting

Q
WARNING!
Only perform the steps described within
u
these instructions! All further inspection,
maintenance and repair work must be
performed by an authorised service centre or
a similarly qualified specialist if you cannot
solve the problem yourself!
Suspected malfunctions are often due to causes
that the users can fix themselves. Therefore check
the product using this section. In most cases the
problem can be solved quickly.
Problem Possible
cause
Product does Battery pack
not start not properly
attached
Battery pack
discharged
Battery pack
damaged
Other electrical
defect to the
product
Product does Air vents are
not reach full blocked
power
Unsatisfactory Accessory is
result worn
Accessory
not suitable
for intended
operation
Product Product
suddenly overloaded
stops
Battery pack
discharged
Battery pack
too hot
Excessive Accessory is
vibration or dull/damaged
noise
Bolts/nuts are
loose
Guard cannot Debris
be adjusted
Solution
Attach properly
Remove and
charge battery
pack
Check by
a specialist
electrician
Check by
a specialist
electrician
Clean the air
vents
Replace with a
new one
Use suitable
accessory
Remove the
product from
the workpiece
and switch it on
again
Remove and
charge battery
pack
Remove battery
pack and let it
cool down
Replace with a
new one
Tighten bolts/
nuts
Clean the
product and
lubricate the
guard base if
necessary
GB / CY 17