Drive: Iec Standard Motor; Operator Responsibilities; Application/Use; Intended Use - Wilo -Atmos GIGA-N Einbau- Und Betriebsanleitung

en
2.8

Drive: IEC standard motor

2.9

Operator responsibilities

3

Application/use

3.1

Intended use

3.2

Improper use

48
Application/use
▪ Only carry out the maintenance tasks described in these installation and operating in-
structions.
▪ Only original parts from the manufacturer may be used for maintenance and repairs.
Use of parts other than original parts releases the manufacturer from any liability.
▪ Collect any leakage of fluid and operating fluid immediately and dispose of it according
to the locally applicable guidelines.
▪ Store tools at the designated locations.
▪ After completing work, reattach all safety and monitoring devices and check that they
function properly.
The hydraulics have a standardised connection flange for installing an IEC standard mo-
tor. See the technical data for the performance data (e.g. size, construction, hydraulic
rated power, speed) needed to select a motor.
The operator must:
▪ Provide the installation and operating instructions in a language which the personnel
can understand.
▪ Make sure that personnel are suitably trained for the specified work.
▪ Ensure that safety and information signs mounted on the device are always legible.
▪ Train personnel with regard to the operating principles of the system.
▪ Eliminate any risk from electrical current.
▪ Equip hazardous components (extremely cold, extremely hot, rotating, etc.) with an on-
site guard.
▪ Demarcate and cordon off the hazardous area.
▪ Define personnel responsibilities to ensure safe working practice.
Children and persons younger than 16 years or with reduced physical, sensory or mental
capacities or limited experience are prohibited from handling the device! Persons under
the age of 18 must be supervised by a technician.
The glanded pumps in the Wilo-Atmos GIGA-N series are intended for use as circulators
in building services.
The Wilo-Atmos GIGA-N pumps may only be used for:
▪ Hot-water heating systems
▪ Cooling and cold water circulation systems
▪ Drinking water systems (special version)
▪ Industrial circulation systems
▪ Heat carrier circuits
▪ Irrigation
The pumps are only approved for the fluids specified in the "Technical data" section.
WARNING! Misuse of the pump can lead to dangerous situations and damage.
▪ Never use with fluids that have not been approved by the manufacturer.
▪ Non-permitted substances in the fluid can destroy the pump. Abrasive solids (e.g. sand)
increase pump wear.
▪ Highly flammable materials/fluids should always be kept at a safe distance from the
device.
▪ Never allow unauthorised persons to carry out work.
▪ Never operate the pump beyond the specified limits of use.
▪ Never carry out unauthorised conversions.
▪ Use authorised accessories and genuine spare parts only.
Typical installation locations are technical rooms within the building with other do-
mestic installations. No provision has been made for direct installation of the pump in
rooms used for other purposes (residential and work rooms).
Outdoor installation requires a corresponding, special version (motor with anti-con-
densation heater).
WILO SE 2019-04