Siemens SINUMERIK 802D sl Betriebsanleitung Seite 278

Inbetriebnahme der PLC
9.6 PLC-Programmierung
Tabelle 9- 21 PROGRAM CONTROL FUNCTIONS
Instruction
Jump to Label If EN = 1, go to label
n.
Label Label marker for the
jump.
Conditional Return If EN = 1, exit the
from Subroutine
subroutine.
Return from Exit subroutine.
Subroutine
Conditional End If EN = 1, END
terminates the main
scan.
Subroutine If EN ↗, go to
subroutine n.
Tabelle 9- 22 MOVE, FILL AND FIND OPERATIONS
Instruction
Move Byte If EN = 1,
copy i to o.
Move Word If EN = 1,
copy i to o.
Move DWord
If EN = 1,
copy i to o.
278
PROGRAM CONTROL FUNCTIONS
Ladder Symbol
MOVE, FILL AND FIND OPERATIONS
Ladder Symbol
Valid Operands
Enable: EN
Label: WORD: 0-127
Label: WORD: 0-127
Enable: EN
Enable: EN
Label: Constant : 0-63
Valid Operands
Enable: EN
In: VB, IB, QB, MB, AC, Constant, LB
Out: VB, IB, QB, MB, AC, LB
Enable: EN
In: VW, T, C, IW, QW, MW, AC, Constant, LW
Out: VW, T, C, IW, QW, MW, AC, LW
Enable: EN
In: VD, ID, QD, MD, AC, Constant, LD
Out: VD, ID, QD, MD, AC, LD
Drehen, Fräsen, Schleifen, Nibbeln
Betriebsanleitung, 06/2009, 6FC5397-0CP10-6AA0