Technical Data - Cleanmaxx Z 05348 Anleitung

Problem
Low suction force.
The control lamp does not
light up when the device
is connected to the mains
power.
Streaks when cleaning win-
dows or smooth surfaces.

Technical Data

Article no.:
Device
Model:
Voltage supply:
Motor power:
Battery charging time:
Battery operating time:
Collecting container, max. fi ll level: 500 ml
Charger
Model:
Voltage supply:
Output:
Protection class:
05348_de-gb-fr-nl_V0.indb 27 05348_de-gb-fr-nl_V0.indb 27
Possible cause/solution
• Is the collecting container full? Empty it.
• Is the fi lter heavily clogged up? Clean it.
• Is the suction opening/nozzle blocked? Switch off
the device and remove the blockage.
• It is also possible that some smaller items will re-
main stuck to the carpet or will be too big/heavy to
be picked up by the device.
• Is the charger connected to the plug socket and the
connecting socket on the device properly?
• Is the plug socket defective? Try another plug
socket.
• Check the fuse of your mains connection.
• Clean the scraper lip.
• Turn over a worn scraper lip: Pull the scraper lip
sideways out of its holder, moisten with water or
cleaning agent in the rounded area and slide back
into the holder the other way round.
• Replace the scraper lip if necessary: If after turn-
ing the scraper lip over both edges are worn, a
new scraper lip is required. Replace the scraper
lip in the manner described above. To order any
additional spare parts, visit our website:
www.service-shopping.de
• Check the metering of the cleaning agent.
Z 05348
PC-P003W
7.2 V DC (Ni-MH battery pack), 1400 mAh
60 W
approx. 7-11 hours (The fi rst charge lasts for
approx. 12-15 hours.)
approx. 20 minutes
LK-D090020
230 V ~ 50 Hz
9 V DC, 200 mA
II
27
27.01.2014 10:13:59 27.01.2014 10:13:59