Use - Cleanmaxx Z 05348 Anleitung

Use

CAUTION!
❐ Never hold the nozzles close to parts of your body or animals during use and do
not place your hands inside the nozzles. They could become stuck to the device/
injured. Should the cordless vacuum cleaner become stuck, switch the device off
immediately.
❐ Switch on the device only once you have ensured that the suction nozzle, the collect-
ing container, the insert and the fi lter have been inserted correctly.
❐ Always switch the device off fi rst before you replace a nozzle or attach or remove any
other accessories!
❐ On no account should the device be used to suck up the following:
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
❐ Empty and clean the collecting container after every use or when the maximum fi ll
level (marking) is reached during use (see the "Cleaning the Device and Accessories"
chapter).
❐ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge.
❐ Test the wiping attachment on a non-visible spot before using it on sensitive (high-
gloss) surfaces.
❐ Do not use the device when it is connected to the charger.
1. Depending on whether you wish to use the device as a hand-held or fl oor vacuum
cleaner, insert the handle rod or detach it.
2. Place one of the nozzles into the suction opening. However, you can also use the
cordless vacuum cleaner without a nozzle.
6. Empty the collecting container after use and clean its insert and the fi lter on a regular
basis (see the "Cleaning the Device and Accessories" chapter). Also charge up the
battery (see the "Charging Up the Battery" chapter).
05348_de-gb-fr-nl_V0.indb 24 05348_de-gb-fr-nl_V0.indb 24
❐ IMPORTANT: If there is liquid in the collecting container,
do not overfi ll it or do not turn the device over with the
top pointing downwards so that no water can get into the
rectangular ventilation opening in the insert, and thus to
the motor!
3. Press the On/Off switch to switch on the device.
4. Guide the nozzle over the surface to be cleaned. Check
during use whether the maximum fi ll level (marking) on the
collecting container has been reached. If this is the case,
it needs to be emptied.
5. To switch off the cordless vacuum cleaner, press the On/
Off switch.
24
27.01.2014 10:13:57 27.01.2014 10:13:57