Mounting Of Cutter Blade; Mounting Of Nylon Cutting Head - Makita RBC420E Original Bedienungsanleitung

Mounting of cutter blade

Turn the machine upside down, and you can replace the cutter blade easily.
- Insert the hex wrench through the hole in the gear case and turn the support
washer (3) until the hex wrench locks the support washer.
- Loosen the nuts (1) (left-hand thread) by turning clockwise with the socket wrench.
Remove the nuts, and tightening washer (2).
- Mount the cutter blade onto the shaft so that the guide on the support washer fits
in the arbor hole of the cutter blade. Install the tightening washer and secure the
cutter blade with the nuts.
[Tightening torque: 280 – 480 kg·cm]
NOTE: Always wear gloves when handling the cutter blade.

Mounting of nylon cutting head

- Insert the hex wrench (5) through the hole in the gear case and turn the support
washer (3) until the hex wrench locks the support washer.
- Loosen the nuts (1) (left-hand thread) by turning clockwise with the socket wrench.
Remove the nuts and tightening washer (2).
- Screw the nylon cutting head (4) onto the shaft by turning it counter-clockwise.
- Remove the hex wrench.
14
Tighten
Loosen
Hex wrench