Mounting Of Guard - Makita RBC420E Original Bedienungsanleitung

Mounting of guard

To meet the applicable safety provisions, only the tool/guard combinations as
indicated In the table must be used. Failure to do so may result in serious injury or
death to user or bystanders.
Be sure to use genuine MAKITA cutter blade or nylon cutting head.
- The cutter blade must be well clean, sharp and free of cracks or breakage.
If the cutter blade contacts any hard objects or stones during operation, stop the
engine and check the blade immediately.
- Clean and sharpen or replace the cutter blade at least every three hours of
operation.
- The outside diameter of the cutter blade must not exceed 255 mm (10 – 1/32").
Never use any blades surpassing 255 mm (10 – 1/32") in outside diameter.
CAUTION: The appropriate guard must always be installed, for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being properly in
place must never be attempted.
For Metal Cutter Blade
- Install the clamp on the drive shaft so that the projection of the clamp is inserted
into the opening between the gear case and the drive shaft.
Secure the guard with the installation bolts M6 x 30 (1).
For Nylon Cutting Head
- Install the clamp on the drive shaft so that the projection of the clamp is inserted
into the opening between the gear case and the drive shaft.
Secure the guard with the installation bolts M6 x 30 (1).
Star Blade
Nylon Cutting
Head
12
Guard for metal blade
(Guard specifications
Guard for Metal
for both metal blade
Cutter Blade
and cord cutter)
Guard for Nylon
Cutting Head (Guard
specifications for both
Guard for Nylon
metal blade and cord
Cutting Head
cutter)