Assembly Instructions; Assembly Of Engine And Drive Shaft - Makita RBC420E Original Bedienungsanleitung

Assembly instructions

Assembly of engine and drive shaft

CAUTION: Before performing any work on the brush cutter or the string
trimmer, always switch off the motor and pull the spark plug
connectors off the spark plug.
Beware of hot engine parts and sharp blade edges.
Always wear protective gloves!
CAUTION: Start the brush cutter or the string trimmer only after having assembled it
completely.
For RBC420 and RBC420E
- Mount the waist pad (1). When the waist pad is mounted, be sure to confirm that
the wires do not move horizontally.
- Avoid any tendency of the throttle wire to loop at the handle bar.
- After checking the parts, fasten the drive shaft to the engine with four bolts M6 x
18 (2). At this time, fasten also the earth terminal of the stop cord to the engine.
- Attach stand to engine with two bolts M6 x 14 (3).
For RBC 421
- Pass the throttle wire (5) through the rear grip (4) and insert the tube (6) in the
throttle wire (5).
- After checking the parts, fasten the drive shaft to the engine with four bolts M6 x
18 (1). At this time, fasten also the earth terminal of the stop cord to the engine.
- Attach stand to engine with two bolts M6 x 14 (2).
10
Hanger
Throttle wire