Installation / Commissioning; Unpacking The Device; Recommendations; Installation - Acteon satelec Piezotome Solo Benutzerhandbuch

Output characteristics:
No-load voltage: 250 Volts (nominal value without
handpiece)
Min. ultrasound frequency: 28 kHz
Irrigation Á ow rate: from 0 to 120 ml/min (nominal
value)
Adjustment in steps of 10 ml/min (nominal value)
Flush Á ow rate: 120 ml/min (nominal value)
Protection:
Electrical class: Class 1
Electrical safety class: BF
Safety:
Protection against internal malfunctions
2 fuses (mains connector): 5mm x 20mm / 2 AT for 100
1 internal fuse that cannot be accessed by the ope-
rator reference F1: 5mm x 20mm – 10 AT / 250 VAC
Overall dimensions:
Console:
Width: 378mm
Height: 136mm
Height with bracket: 460mm
Depth: 306mm
Weight: 3700g
Pedal:
Depth: 176mm
Width: 173mm
Height with arch: 140mm
Weight: 1000g max
LCD screen:
Height: 86mm
Width: 115mm
Handpiece cable: 2000mm
Temperatures:
Operating: +10°C to +30°C
Storage: -20°C to +70°C
Humidity:
Operating: 30% to 75%
Storage: 10% to 100% including condensation
Atmospheric pressure:
Between 500 hPa and 1060 hPa
8
VAC to 230 VAC
IV - INSTALLATION /
COMMISSIONING

4.1 UNPACKING THE DEVICE

Upon receipt of the device, look for any damage that
may have occurred during transportation.
If necessary, contact your supplier.

4.2 RECOMMENDATIONS

Ask an approved dental installation technician to
make any connection to the electrical network.
The device's electrical connection shall comply with
standards in force in your country.
Warning: To avoid any risk of electric shock, this
device must be connected to an electrical power
supply with a protective ground.

4.3 INSTALLATION

Important:
Do not install P
IEZOTOME
or on another device.
Do not conceal the mains power cable and the pedal
cable in a cable cover or cable guide.
- Place the console on a À xed horizontal surface or a
surface that is not sloped by an angle of more than
5 degrees.
- Check that the mains isolating switch (Fig. 2-5) is in
position O (stop).
- Connect the mains power cable to the device's
mains connector (Fig. 2-1).
- Connect the mains power cable to the electrical
network socket equipped with an earthing pin.
- If necessary, connect the ground equipotential plug
of your installation to the potential equalizing ter-
minal of your device (Fig. 2-6).
- Connect the control pedal to the pedal connector
(Fig. 2-2).
- Position the pedal so that you can easily reach it
with your foot.
- Plug the bracket into the bracket support (Fig. 2-4).
S /P S L
OLO IEZOTOME OLO ED
near to