Time-Delayed Cleaning / Fixed Time; Cleaning And Storage - Silvercrest SSR 3000 A1 Bedienungs- Und Sicherheitshinweise

Note: By pressing the Clean button again on
the robot vacuum cleaner
trol , the product will return to the original
27
cleaning mode.
Corner mode
This mode is suitable for cleaning the corners and
edges of a room. In Corner mode, the product
follows a barrier (for example a wall).
During cleaning, press the Corner mode button
on the remote control to start this mode.
28
In this mode, the product will return to the
charging dock after cleaning.
2
Note: You can end Corner mode by pressing
the Clean button once on the robot vacuum
cleaner or on the remote control
11
Note: By pressing the Clean button again on
the robot vacuum cleaner
control , the product will return to the original
27
cleaning mode.
Time-delayed cleaning /
fixed time
Using this function, you can set a time period, after
which the product will begin cleaning. Smallest time
period: 15 minutes, largest time period: 23 hours
and 45 minutes.
Press the Clean button on the robot vacuum
cleaner or on the remote control
11
notification is visible in the display
Press the Set schedule button on the robot vac-
uum cleaner or the remote control
12
last two digits in the display
Using the Return mode
buttons on the robot vacuum cleaner, set the
desired time in minutes (00, 15, 30, 45). To do
this, you can also use the directional buttons
on the remote control.
26
Press the Set schedule button on the robot vac-
uum cleaner or on the remote control
12
again. The first two digits in the display
flash.
or the remote con-
11
.
27
or the remote
11
(if no
27
).
1
. The
30
will flash.
1
and Spot mode
13 14
30
will
1
Using the Return mode
buttons on the robot vacuum cleaner, set the
desired time in hours (01 - 23). To do this, you
can also use the directional buttons
remote control.
Finally, press the Clean button on the robot
vacuum cleaner
11
to confirm your selections.
27
After the set time has expired, the product will turn
itself on automatically and begin cleaning.
Note: If you turn the product off using the power
switch , the saved settings will be lost.
9

Cleaning and storage

Set the power switch
cleaning the product.
Unplug the mains lead
socket before cleaning the product.
Do not rinse the product directly with water.
Do not wipe the product with a cloth soaked in
water.
Disconnect the power supply if the product will
not be used for an extended period.
Cleaning the dust collector
Open the product by pressing on the cover
where it says PUSH.
Remove the dust collector
pushing the cover
22
Remove the main filter
collector .
21
Fold the dust collector cover
remove the filter frame
HEPA filter from the outside of the dust
5
collector .
21
Rinse the dust collector
or clean it using a damp cloth. Then wipe the
dust collector until it is dry.
21
Clean the main filter
with the cleaning brush
filters when they are dry.
First, insert the HEPA filter
frame , then insert into the dust collector
24
and Spot mode
13
on the
26
or on the remote control
to position „O" before
9
from the mains
4
and open it by
21
upwards.
and empty the dust
23
forwards and
22
together with the
24
under running water
21
and the HEPA filter
23
. Only reinstall the
7
back into the filter
5
GB/IE
14
10
5
.
21
27