Set-Up; Charging The Product; Switching The Product On / Off - Silvercrest SSR 3000 A1 Bedienungs- Und Sicherheitshinweise

suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Robot vacuum cleaner only
This product has a built-in lithium-
ion rechargeable battery which
cannot be replaced by the user.
The rechargeable battery must be
removed or replaced by the manuf-
acturer or their service centre or a
similarly qualified person to avoid
hazards. When disposing of the
product, you must indicate this
product contains a rechargeable
battery.

Set-up

Charging the product

Fully charge the product before using it for the first
time. It takes approx. 3 to 5 hours to charge. The
charging process is also indicated in the display
Set up the charging dock
mains lead .
4
Place the charging dock
Note: Keep 1 m from the left / right and 2 m
from the front clear.
Place the product in the charging dock
align it with the charging contacts
Note: The product automatically returns to the
charging dock when the battery is low.
2
You can alternatively directly connect the
mains lead to the charging socket
4
the product.

Switching the product on / off

Press the power switch
product. „I" indicates switched on, „O" indi-
cates switched off. If the display
the product was switched on successfully.
Note: Do not switch off the product after it has
finished cleaning. Leave it in the charging dock
so that it is ready for the next cleaning session.
.
1
and connect the
2
flush against a wall.
2
and
2
.
3
on
8
on the side of the
9
lights up,
1
2
GB/IE 25