Replacing Parts; Replacing The Side Brushes; Replacing The Hepa Filter; Troubleshooting / Problem Solving - Silvercrest SSR 3000 A1 Bedienungs- Und Sicherheitshinweise

Close the cover of the dust collector
sure that it audibly clicks into place, and insert
the dust collector
21
Close the cover
10
it audibly clicks into place.
Cleaning the brushes
Regularly remove any hair and dirt from the
side brushes .
17
Cleaning the main housing
Clean the 3 anti-fall sensors
their sensitivity.
Clean the front wheel
tangled in it.
Clean the anti-collision sensor
its sensitivity.

Replacing parts

Replacing the side brushes

If the side brushes are worn out, they can be
17
replaced with the supplied replacement side
brushes .
6
Loosen the old side brushes
underside using a cross-tip screwdriver (not
included in the delivery contents).
Screw the replacement side brushes
place.

Replacing the HEPA filter

Depending on the frequency of use, the HEPA filter
should be cleaned after approx. 15 to 30 days.
5
After approx. 6 months it should be replaced with
the supplied replacement filter.
Remove the old HEPA filter
„Cleaning and storage").
Insert the new HEPA filter
28 GB/IE
, making
22
back into the product.
of the product, making sure
to maintain
18
to remove any hair
19
to maintain
20
fixed to the
17
into
6
(see chapter
5
.
5
Troubleshooting /
Problem solving
If the product is not working correctly, the display
will show various error codes and emit signal
1
tones of different lengths. Please refer to the table
below for troubleshooting.
After troubleshooting, press the Clean button on the
robot vacuum cleaner
11
Problem Possible
cause
No function. Battery is not
fully charged.
Power switch
switched to
9
"O".
Battery contacts
are dirty.
Poor suction
Suction vent
power..
is blocked.
Dust collector
is full or the
21
filters
are blocked.
Error code Possible
cause
E01 Left side wheel
does not turn.
E02 Right side
wheel does not
turn.
E04 Product was
lifted up
or on the remote control
Trouble-
shooting
Charge the
battery fully.
Switch the
power switch
to "I".
9
Clean the
charging con-
tacts and
3
the battery
contacts on
the product.
Check the suc-
16
tion vent
16
Proceed as
described in
, the chapter
5 23
"Cleaning and
storage".
Possible
trouble-
shooting
Check the left
side wheel
and clean it if
necessary.
Check the right
side wheel
and clean it if
necessary.
Place the
product back
on the floor
.
27
.