Cleaning And Maintenance; Emptying The Dirt Container And Cleaning The Filter - Silvercrest SST 40 A1 Kurzanleitung

Cleaning and maintenance

WARNING
► Always disconnect the mains adapter l from the mains socket. Pull the barrel
plug k out of the connecting socket
CAUTION
► Do not use abrasive or aggressive cleaning materials.
These can damage the surface of the appliance!
NOTE
► The LED light i is maintenance-free. The LEDs cannot be replaced!
Emptying the dirt container and cleaning the filter
NOTE
► For the best vacuuming results, empty the dirt container 0 and clean the HEPA
filter p at regular intervals.
♦ Lift the release lever 9 and pull the dirt container 0 forwards off the appliance
(see fig. 13) at the same time.
♦ First remove the HEPA filter p and then the coarse filter o from the dirt contain-
er 0 (see fig. 14). Tap out both parts over a waste bin or similar. If necessary,
you can rinse the HEPA filter p in fresh water. Afterwards, let it dry out completely.
♦ Empty the dirt container 0 over a dustbin or similar.
♦ First insert the coarse filter o and then the dry HEPA filter p into the dirt
container 0.
♦ Push the dirt container 0 into the motor unit 8 until it clicks into place
(see fig. 15).
1.
2.
Fig. 13
SST 40 A1
4 of the appliance.
Fig. 14
2.
1.
Fig. 15
GB │ IE │ 15 ■