Side Mounting - Agilent Technologies TV 551 Navigator Bedienungshandbuch

17 Technical Information
TV 551/701 Controller Installation

Side Mounting

The L-shaped bracket (P/N 969-9349) is available as an option.
NOTE
See the following figure.
1
2
3
4
5
6
7
8
9
286/300
Place the L-shaped bracket on the controller, with the pump
cable toward the bracket, and fix it by means of the three socket
head screws M5, the washers and the nuts. The 6 holes on the
bracket allows to mount the controller with the rotation angle
that you like;
Turn the pump upside-down;
Place the bracket on the pump bottom (the hole on the bracket
has the same diameter as the pump bottom flange);
Screw a little bit the three screws M6 in the holes on the pump
bottom;
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
TV 551/701 Navigator User Manual / 87-900-934-01 (M)