Side Mounting - Agilent Technologies TV 301 Navigator Bedienungshandbuch

Side Mounting

The L-shaped bracket (P/N 969-9970) is available as an option.
NOTE
See the following figure.
1
2
3
4
5
6
7
8
9
10 Plug the line cord and connect the pump cable to the pump;
11 Connect the mating connector with the jumper on the interlock
TV 301 Navigator User Manual / 87-900-946-01
Screw the 4 fixing studs (provided with the accessories bag) in
the holes on the L-shaped bracket;
Place the controller on the studs aligning the 4 rubber holes on
the top of the controller;
Press the controller towards the bracket;
Turn the pump upside-down;
Place the bracket on the pump bottom;
Screw a little bit the three screws M4 in the holes on the pump
bottom;
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
signal to start the pump.
Technical Information
TV 301Controller Installation
(M)
17
267/282