Charging Mode 3; Charging Mode 1; (Only Smart* S, Premium* S) - Mennekes Premium* 3,7 Betriebs Und Installationsanleitung

Terminating the charging process
T
T
ATTENTION
Damage to the charging cable
Pulling the cable may cause cable breaks and other dama-
ges.
f Remove the charging cable only by pulling the plug
from the charging socket.
f Terminate the charging process at the vehicle.
f Remove the charging cable by pulling the plug from the
charging socket.
f Remove the charging cable from the vehicle.
Power failure during charging process
A power failure aborts the charging process.
The charging plug inserted into the charging socket of the
charging station is released and can be removed. If the
charging plug cannot be removed from the charging stati-
on, an actuator has interlocked the charging plug mecha-
nically.
Î "9. Troubleshooting"
Re-authorisation is necessary once the charging system is
restored and ready for use following a power failure.
Î "7.1 Authorisation"
7.3

Charging mode 1

(only Smart* S, Premium* S)

T
T
WARNING
Risk of injury by unsuitable aids
Use of adapter plugs, extensions, or additional charging
cables in connection with the device can result in electric
shock or cable fire.
f Use only the charging cable intended for the vehicle
and the device.
f Do not use adapter plugs, extensions, or additional
charging cables to charge the vehicle.
Fig. 22: Charging mode 1
Starting the charging process
The authorisation process is complete.
Î "7.1 Authorisation"
f Connect the charging cable to the vehicle.
f Insert the plug fully into the charging socket SCHUKO®
of the charging station.
The charging system supplies a maximum charging current
of 13 A.
9 The contactor is activated.
The plug is not mechanically locked. The vehicle can
9
now be charged.
EN
21