Commissioning; Basic Settings Via Dip Switch; Configuring The Product; Setting The Maximum Charging Current - Mennekes AMTRON Compact 2.0 11 Betriebs Und Installationsanleitung

6

Commissioning

6.1

Basic settings via DIP switch

Changes made via the DIP switches only
take effect after restarting the product.
u Disconnect product from voltage if necessary.

6.1.1 Configuring the product

The tasks described in this section may only
be carried out by a qualified electrician.
In the top section of the housing, there are two 8-
pin DIP switches, with which the device can be con-
figured. In the delivery state, all DIP switches are
switched off ("OFF"). On delivery, the product is
ready for connection.
Fig. 9: DIP switch (delivery state)
1 Bank S1
2 Bank S2
The following functions can be set via the DIP
switches:
Bank S1
DIP Function
switch
1 LED display colour scheme
n "OFF":
n "Standby" symbol = blue
n "Charging" symbol = green
n "ON":
n "Standby" symbol = green
n "Charging" symbol = blue
2 Unbalanced load limitation
n "OFF": Unbalanced load limitation off
n "ON": Unbalanced load limitation on
3 Authorisation
n "OFF": No authorisation (Autostart)
n "ON": Authorisation via the enable in-
put
4, 5, 6, Without function
7, 8
Bank S2
1
DIP Function
switch
1, 2, 3 Max. charging current
2
4, 5 Reduced charging current when down-
grade input is energised
6,7,8 Without function

6.1.2 Setting the maximum charging current

The tasks described in this section may only
be carried out by a qualified electrician.
The maximum charging current of the charging
point can be set via DIP switches 1, 2 and 3 on bank
S2.
AMTRON® Compact 2.0 22
The maximum charging current can be set to 6 A,
10 A, 13 A, 16 A, 20 A, 25 A or 32 A.
EN
17