Attaching The Grinding Disc; Fitting The Connector Nipple - Parkside PDWS 125 A1 Bedienungsanleitung

Attaching the grinding disc

CAUTION!
► Disconnect the compressed air tool from
the compressed air supply before replacing
the accessory tool or accessories, or before
carrying out adjustments or servicing. The
spindle must be at a standstill.
Lock the spindle
♦ Place the rear clamping flange
. This is correctly attached if the spindle
cannot be rotated.
♦ Place the open-ended spanner
over the collar of the rear clamping flange
prevent it from turning.
Attaching the grinding disc
♦ Place the grinding disc
flange .
The grinding disc
the rear clamping flange
Fixing/loosening the front flange
The 2 sides of the front flange
Screw the front flange
follows:
For thin grinding discs (see figure 1):
♦ The collar on the front flange
so that the thin grinding disc
clamped.
fig. 1
│ GB │ CY
■ 10
on the spindle
supplied
on the rear clamping
must be evenly placed on
.
are different.
onto the spindle as
faces upwards
can be safely
≤ 3,2 mm
For thick grinding discs (see figure 2):
fig. 2
The collar on the front flange
so that the front flange
to the spindle
♦ Locking the spindle
♦ Tighten the front flange
to
tion using the two-hole spanner
Loosening the front flange:
♦ Lock the spindle
♦ Undo the front flange
direction using the two-hole spanner

Fitting the connector nipple

♦ Remove the plastic protective cap from the
appliance's air inlet.
♦ Wrap the threads on the connector nipple
with the teflon tape
♦ Screw the connector nipple
12
faces downwards
can be safely attached
.
.
in a clockwise direc-
.
.
in an anticlockwise
supplied.
into the air inlet.
PDWS 125 A1
> 3,2 mm
.