UNIT CONTROLLER
8.6.4.3 Screed Drying
REF
Access
SDC1
Circuit 1 Setting T
SDC2
Circuit 2 Setting T
-
Start Screed Drying
?
N O T E
•
(*1): If Water calculation mode for circuit 1 heating (C1WC) or Water calculation mode for circuit 1 cooling (CC1WC) are not set as "Disabled".
•
(*2): If Water calculation mode for circuit 2 heating (C2WC) or Water calculation mode for circuit 2 cooling (CC2WC) are not set as "Disabled".
8.6.5 About
In this menu, it is possible to consult some useful information. There are two main options:
•
System Information
•
Contact Information
8.6.5.1 System Information
System information view will give the version number of the Yutaki and the PC-ARFHE. It will be done in a view as the following one:
In this view, nothing can be edited.
It will appear:
•
Unit Type (S/SC/S80/M)
•
Unit Capacity
•
Controller Firmware: is the H-0XX software name of the LCD
•
Indoor PCB Firmware: ROM Number is a variable read from H-LINK, it is the 11-302
variable and transformed to H-00XX
•
Language Package: group of available languages
8.6.5.2 Contact Information
In the contact information, it can be entered:
•
Name: every character could be entered from HAPE Ascii character map
•
Phone Number: every number can be from 0 to 9 and "-"
These variables are only editable in the installer mode.
After changing a letter a broadcast message is set at informing to all the slave devices the new text to have all of them synchronized.
166
PMML0335A rev.1 - 04/2016
Default
Description
Value
Screed Drying
55
55
-
Range
Steps Units
Limits installer
1
ºC
Limits installer
1
ºC
-
-
Application
Notes
S
SC
S80
M
○
○
○
○
(*1)
○
○
○
○
(*2)
-
○
○
○
○