(*1): If Controller type (LCDM)= "Unit" or "Unit + Room" and Controlled circuits (LCDL)="Room C2" or "C1+C2".
•
(*2):If cooling operation is enabled and if Controller type (LCDM)= "Room" or "Unit + Room" and Controlled circuits (LCDL)="Room C2" or "C1+C2".
•
(*3):If Controller type (LCDM)= "Unit" or "Unit + Room" and Water calculation mode for circuit 2 heating (C2WC) is not "Disabled".
•
(*4): If cooling operation is enabled and if Controller type (LCDM)= "Unit" or "Unit + Room" and Water calculation mode for circuit 2 cooling
(CC2WC) is not "Disabled".
Timer and Schedule 'any of the previous views'
Each of the following submenus share these parameters shown on the table
•
Circuit 1 Heating (Air)
•
Circuit 1 Cooling (Air)
•
Circuit 1 Heating (Water)
•
Circuit 1 Cooling (Water)
•
Circuit 2 Heating (Air)
•
Circuit 2 Cooling (Air)
•
Circuit 2 Heating (Water)
•
Circuit 2 Cooling (Water)
•
DHW
•
SWP
REF
Access
-
Timer Type
-
Timer configuration (*)
-
Copy to Circuit 2 (*)
-
Copy to Circuit 1 (*)
-
Frequency (*)
-
Starting time
-
Mode
-
Setting Temperature
-
Stopping time
-
Configuration Parameters
-
Change Mode
-
Reset configuration
?
N O T E
•
(*1): If timer type= "Schedule".
•
(*2): If time type= "Schedule" and if the selected timer is "Circuit 1" (Air/Water) and if exist 2 circuits in the same controller and the timer mode is