This chapter explains navigation through the menus of the controller. For more specific information about particular options in these menus, refer to the
chapters
Control system
and
Optional functions
In order to access to the main menu, press " " the button.
The main menu contains the following features:
•
Operation information
•
System configuration
•
Controller settings
•
Commisioning
•
About
•
Factory reset
•
Return to user mode
: Available only for installer.
8.6.1 Operation information
In this sub-menu, the current information about the performance of the unit is displayed.
"Operation information" contains the following features:
•
General
•
Circuit 1 (*1)
•
Circuit 2 (*2)
•
DHW (*3)
•
Swimming Pool (*4)
•
Heat Pump
•
Electrical Heater (*5)
•
Boiler Combination (*6)
•
Solar Combination (*7)
•
Alarm History
•
Energy Data (*8)
?
N O T E
•
(*1):If Water calculation mode for circuit 1 heating (C1WC) or Water calculation mode for circuit 1 cooling (CC1WC) not "Disabled".
•
(*2): If Water calculation mode for circuit 2 heating (C2WC) or Water calculation mode for circuit 2 cooling (CC2WC) not "Disabled".
•
(*3): If Status (DHWs)= "Enabled".
•
(*4): If Status (SWP)= "Enabled".
•
(*5): If Heating source (HES)= "HP+EH" or "HP+EH+Bo.".
•
(*6): If Heating source (HES)= "HP+Boiler" or "HP+EH+Bo.".
•
(*7): If Solar combination (SOLStSet)= "Input demand" or "Total".
•
(*8): If (Status (PMConf)= "Enabled" or Capacity configuration (CAPCo.)= "Enabled") and the Controller type (LCDM) = "Unit" or "Unit + Room" in