End Of Work; Cleaning The Machine - GGP ITALY 102 Gebrauchsanweisung

– pull out the lever (1) and tip up the
grass-catcher to empty it;
– close up the grass-catcher so that it
hooks onto the pawl stop (2).
NOTE
At times the audi-
ble warning may be heard at the mo-
ment of engaging the blade even
when the grass-catcher has been
emptied. This is due to grass-cuttings
left on the sensor of the micro-switch.
To stop the signal, disengage the
blade and then immediately engage it
again.
Always keep the sensor (3) free of
grass-cuttings.
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly at too high speed, can
cause the collector channel to become blocked.
Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades
and stop the engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit
of the collector channel.
WARNING!
This job must only be performed with
the engine turned off.
2
1
3
5.4.8 End of mowing
When you have finished mowing, disengage the blades, lower
the engine speed and ride the machine with the cutting deck in
the highest position.

5.4.9 End of work

Stop the machine, put the accelerator
lever in the «SLOW» position and turn
off the engine by putting the key into
the «OFF» position.
When the engine is stopped, close the
fuel stopcock (1) (if fitted).
WARNING!
To avoid backfire, put the accelerator
in the «SLOW» position for 20 seconds before stopping
the engine.
WARNING!
Always take out the ignition key if
leaving the machine unattended!
IMPORTANT
To keep the battery charged, do not leave
the key in the «ON» position when the engine is not running.

5.4.10 Cleaning the machine

After each mowing, clean the outside of the machine, empty the
grass-catcher and shake it to remove residual grass and earth.
1
EN 23