Useful Information - GGP ITALY 102 Gebrauchsanweisung

5.4.11 Storage and inactivity for long periods
If you intend not to use the
machine for a long period
(more than 1 month), dis-
connect the battery cables
and follow the instructions
in the engine instruction
manual.
Empty the fuel tank by dis-
connecting the tube (1) sit-
uated at the inlet of the
fuel filter (2), and collect the fuel in a suitable container.
Reconnect the tube (1) making sure you position the clip prop-
erly (3).
WARNING!
Carefully remove any dry grass cut-
tings which may have collected around the engine or si-
lencer to prevent their catching fire the next time the ma-
chine is used!
Put the machine away in a dry place protected from weather
and, if possible, cover with a cloth (
IMPORTANT
The battery must be kept in a cool and
dry place. Before a long storage period (more than 1 month),
always charge the battery, and then recharge before using
again ( 6.2.3).
The next time the machine is used, check that there are no fuel
leaks from the tubes, fuel stopcock or carburettor.
2 3 1
9.4).

USEFUL INFORMATION

5.4.12
A) Card protection device
The electronic card has a self-resetting protector which breaks
the circuit if there is a fault in the electrical system. It results in
the stopping of the engine and an audible signal which can only
be stopped by removing the key.
The circuit automatically resets after a few seconds but the
cause of the fault should be ascertained and dealt with to avoid
re-activating the protection device.
IMPORTANT
To avoid activating the protection device:
– do not reverse the leads on the battery terminals;
– do not use the machine without its battery or damage may
be caused to the charging regulator;
– be careful to not cause short-circuits.
B) Warning lights
The fuel warning light ( 4.7.d) (if fitted) informs you that there
are only 2 litres of fuel left in the tank, which is enough for 30-40
minutes of normal work.
IMPORTANT
If, while running:
– the battery warning light comes on (
of this manual.
– the oil warning light comes on (
means that there is not enough lubrication and so the en-
gine must be stopped immediately.
4.7.g): see chapter 8
4.7.e) (if fitted): this
EN 25