Brake Pedal - GGP ITALY 102 Gebrauchsanweisung

«A» Released = Blades disengaged
«B» Pressed = Blades engaged
– If the blades are engaged when safety conditions have not
been complied with, the engine shuts down and cannot be
restarted ( 5.2).
– The "Blades engaged" condition is indicated by a pilot lamp
(4.7.a).
– On disengaging the blades, a brake is simultaneously acti-
vated which stops their rotation in few seconds.
4.10 CUTTING HEIGHT ADJUSTING LEVER
There are seven positions for this lever, shown as «1» to «7» on
the label, which correspond to various heights of between 3 and
9 cm.
– To go from one height to another, press the release button at
the end of the lever.
4.11 LEVER FOR TIPPING THE GRASS-CATCHER
This lever, when pulled out from its hole, is to tip the grass-
catcher to empty it and reduce the effort required by the
operator.

4.31 BRAKE PEDAL

This pedal works the brake on the rear wheels.
4.32 DRIVE ENGAGEMENT PEDAL
This pedal engages drive
in the wheels as well as
modulating the ma-
chine's forward and re-
verse speeds.
– To engage forward
drive just press it in
the «F» direction with
your toe-cap, noting
that increasing the
pressure on the pedal
progressively in-
creases the speed of
the machine
– Reverse is engaged
by pressing the pedal
with the heel, in the
«R» direction.
– The pedal automati-
cally goes into neutral
«N» when released.
– The neutral condition
«N» is shown by the lighting of a pilot lamp (4.7.h).
WARNING!
Reverse must only be engaged when
the machine is stopped.
NOTE
If the drive pedal is used, whether for-
wards or for reverse, when the parking brake (4.5) is engaged,
the engine stops.
4.31
4.32
N
F
R
B
4.33
A
EN 15