GGP ITALY 102 Gebrauchsanweisung Seite 90

3.5 GRASS-CATCHER SUPPORT ASSEMBLY
Fit the two brackets (1) on
the rear plate (2), using for
each bracket three screws
(3) which are supplied, as
shown, without fully tight-
ening the nuts (4).
Hook the upper part of the grass-catcher frame (5) onto the
brackets and centre it up with the rear plate (2).
Adjust the position of the
two brackets (1) to the
stop (6) so that, when
turning the grass-catcher
frame, the pin (7) slots
into the seat (8) correctly.
Check again that the
frame (5) is properly cen-
tred with the rear plate (2)
and that it rotates correct-
ly, as shown above, and
then fully tighten the
screws (3) and the nuts
(4).
3
1
5
1
6
8
7
1
3.6 REMOVAL OF THE STOP FROM THE HOOKING PAWL
OF THE GRASS-CATCHER
For transport purposes, the pawl
(1) hooking the grass-catcher is
4
held onto the rear plate by a stop
(2).
This stop must be removed before
fitting the grass-catcher brackets,
and is not to be subsequently
2
used.
3.7 MOUNTING THE
FRONT BUMPER
(if provided)
Mount the front bumper (1) on
the bottom of the frame (2) us-
2
ing the four screws (3).
3.8 GRASS-CATCHER ASSEMBLY
The grass-catcher is assembled in four stages:
A) First of all assemble the frame, joining the upper part (1) to
5
the lower part (2) using the supplied screws and nuts (3) as
1
2
1 3
EN 11
2