GGP ITALY 102 Gebrauchsanweisung Seite 91

8
15
16 -17
16
4
15
R
17
1 2
3
3 2
shown. Position the angle plates (4) and (5), making sure that
they are for the right (R ) and left (L ), sides, and attach them
to the frame using the four self-threading screws (6).
B) Insert the frame in the canvas cover (7) making sure it is cor-
rectly positioned on the base perimeter. Hook the plastic profiles
onto the frame tubes with the aid of a screw-driver (8).
C) Insert the handle (9) into the holes of the canvas cover (10).
Attach this to the frame using the screws (11), following the indi-
cated sequence, and then the self-threading screws (12) at the
rear.
D) Attach the stiffening bar (13) under the frame with screws
and nuts (14) keeping the flat part turned towards the canvas.
Insert the emptying lever (15) in its position and put in the limit
stop screw (16) with its nut (17).
EN 12
9 12
9
10
1
6
5
L
2
7
6
14 13
13 14
11
6
4 - 5