Parking Brake Lever; Light Switch - GGP ITALY 102 Gebrauchsanweisung

On being released at the «START» position, the key will auto-
matically return to «ON».

4.5 PARKING BRAKE LEVER

This lever is to stop the machine from moving when it has been
parked. There are two positions:
«A» = Brake off
«B» = Brake engaged
– The brake is engaged by fully pressing the pedal (4.31) and
moving the lever to position «B». When you take your foot off
the pedal it will be blocked by the lever in the down position.
– A pilot lamp will warn that the brake is engaged (4.7.b).
– To disengage the parking brake, press the pedal (4.31). The
lever will return to position «A».

4.6 LIGHT SWITCH

For turning on the lights when the key (4.4) is in the «ON» posi-
tion.
4.7 PILOT LAMPS AND AUDIBLE WARNINGS
There is a panel on the dashboard with a set of pilot lamps which
work when the key (4.4) is in the «ON» position.
EN 14
– The lighting of these lamps means:
a) blades engaged;
b) parking brake engaged;
c) seat without operator;
d) (if fitted) low fuel;
e) (if fitted) problems in the engine oil;
f) missing grass-catcher or stone-guard;
g) insufficient battery recharge;
h) transmission in "neutral" position.
– There are two types of audible warning:
a) continuous the electronic card's protection device
has cut in;
b) intermittent warning that the grass-catcher is full.
4.8 HOUR COUNTER (if fitted)
This starts working every time the key is put into the «ON» posi-
tion and shows the number of hours the engine has been run-
ning.
4.9 BLADE ENGAGEMENT AND BRAKE CONTROL
The pushbutton (4.9) is for engaging the blades by an electro-
magnetic clutch: