Using The Machine - Stiga RECYCLING VE32 Gebrauchsanweisung

4.1.3 Height adjustment
The spiral cutter can be set to 6 different height po-
sitions according to the table below. Change posi-
tion as follows:
1. Pull out the lever (4:Q).
2. Set the lever to the desired position.
3. Release the lever so that it locks in the new po-
sition.
Spiral cutter's position
Transport position.
13 mm above the ground.
Cleaning position A.
3 mm above the ground.
Cleaning position B.
At ground level.
Cuts 3 mm down into the
lawn.
Cuts 6 mm down into the
lawn.
Cuts 10 mm down into the
lawn.
ENGLISH
Lever's position
5.1 Vertical cutting
Making vertical cuts in the lawn achieves the fol-
lowing benefits:
• The air can penetrate down into the soil layer,
• Loose moss can be scarified and gathered in the
• The grass roots are divided, so increasing in
5.2 Before use
When performing vertical cutting, the grass must
be as short as possible, ideally not more than 4 cm
long. Vertical cutting can be carried out with or
without a collector. If the collector is not used, the
waste will be dropped and distributed evenly be-
hind the machine.
5.3 During use
Connect the machine using an extension lead to a
230 VAC electric socket. See "4.1.1 Electric sock-
et and relieving loop". The electric socket must
have a 10 A fuse.
Set the desired cutting depth and start the machine.
Start working on the lawn as close to the mains
electric socket as possible in order to minimise the
risk of running over the cable. The cable must not
be run over under any circumstances.
Never stretch the cable; it should remain in a loose
loop at the side of the machine.
5.4 After use
Stop the machine and disconnect the connection
cable.
Clean the machine with a soft brush and a moist
cloth.
Store the machine in a cool, dry location.

5 USING THE MACHINE

The machine must be connected via an
earth leakage circuit breaker with fault
current 30 mA. There is otherwise a
risk of fatal electric shocks.
Never run over the extension lead. Risk
of fatal electric shocks.
making it easier for moisture to evaporate. This
counteracts the growth of moss.
collector.
number. This produces a denser lawn with more
blades of grass.
The machine must not be rinsed with
water. This will damage the machine's
electrical components and can produce
fatal electric shocks.
EN
25