Identification Label (Fig. 1); Safety Key (Deactivation Device); Using The Machine - Stiga T 300 Li 20-Serie Gebrauchsanweisung

3.3

IDENTIFICATION LABEL (Fig. 1)

1. Sound power level.
2. Conformity marking.
3. Year of manufacture.
Type of machine.
4.
5. Serial number.
6. Name and address of Manufacturer.
7. Article code.
8. Max. motor operation speed.
9. Weight in kg.
10. Power supply voltage
11. Electrical protection rating.
12. Nominal power.
Write the identification data of the machine in the specific
space on the label on the back of the cover page.
IMPORTANT Quote the data on the product identification
label whenever you contact an Authorised Service Centre.
IMPORTANT The example of the Declaration of
Conformity is provided on the last pages of the manual.
3.4 SAFETY WARNING SIGNS (Fig. 1).
The machine has various symbols on it.
Meaning of symbols:
Warning. Read the instructions
before operating the machine.
Danger! Risk of hurled objects.
Keep all persons away from the
work area whilst working.
Be careful when using the sharp cutting
means. Do not put hands or feet near or
under the opening of the cutting means.
The cutting means continues to turn
even after the motor has been switched
off. Remove the safety key (deactivation
device) before doing maintenance.
Any damaged or illegible decals must be
IMPORTANT
replaced. Order replacement decals from an authorised
service centre.
4. ASSEMBLY
The safety regulations to follow are described in
chap. 2. Strictly comply with these indications to avoid
serious risks or dangers.
For storage and transport purposes, some components of
the machine are not installed in the factory and have to be
assembled after unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for moving the machine and its packaging, al-
ways making use of suitable equipment. Do not use the
machine until all the indications provided in the "AS-
SEMBLY" section have been carried out.
Before assembling, make sure the safety key is
not inserted in its housing.
4.1 UNPACKING (Fig.2)
4.2 ASSEMBLY THE HANDLE (Fig.3)
Assemble the upper handle with the lower handle (fig.I-II) and
then assemble it on the machine body (fig.III) as shown.
5. CONTROLS
5.1

SAFETY KEY (DEACTIVATION DEVICE)

The key (Fig.1.H) found inside the battery compartment
enables / disables the machine electric circuit.
Removing the key, the electric circuit is completely deactivated
to prevent uncontrolled use of the machine.
IMPORTANT Remove the safety key whenever the machine
is unused or left unattended.
5.2 CONTROL LEVER
The control lever (Fig.4) starts/stops the motor and
simultaneously engages/disengages the cutting means.
The positions indicated correspond to:
Ignition. Press the safety button (fig.4.A.1)
and pull the lever (fig.4.A) to ignite the motor.
Cutting means engagement. Ignition of the
motor simultaneously engages the cutting
means.
Stop. The motor stops automatically
when the lever is released (Fig.4.A).
NOTE The cutting means engagement is possible only
by pressing the button on the right side of the handle and
bringing the operator presence lever towards the handle.
6.

USING THE MACHINE

The safety regulations to follow are described in
chap. 2. Strictly comply with these indications to avoid
serious risks or dangers.
6.1 PRELIMINARY PROCEDURES
Make sure the safety key is not inserted in its housing. Place
the machine in a stable horizontal position on the ground.
EN - 4