Stiga RECYCLING VE32 Gebrauchsanweisung Seite 24

EN
2 GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
Before commencing installation, care-
fully read these instructions and safety
instructions.
2.1 References
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
"2:C".
3 ASSEMBLY
To avoid injuries and damage to prop-
erty, do not use the machine until all the
measures in these instructions have
been carried out.
3.1 Wheels
Install the four wheels on the wheel axles in accor-
dance with fig. 1. Use the components below:
• Wheel 1:C.
• Locking washer 1:B.
• Wheel cap 1:A.
Install the rear wheel axle on the underside of the
machine in accordance with fig. 2. The angled
ends of the axle must fit into the slots in the side of
the machine. Use the components below:
• 2 locking loops 2:E (the smaller size).
• 4 screws with washers 2:F.
Install the front wheel axle on the underside of the
machine in accordance with fig. 2. The axle's
height adjustment lever must fit into its locking de-
vice on the right side of the machine. Use the com-
ponents below:
• 2 locking loops 2:G (the larger size).
• 4 screws with washers 2:F.
3.2 Handle
3.2.1 The handle's lower section
1. Install the cable holder 3:K on the handle's low-
er section.
2. Press the handle's lower section down into the
machine.
3. Lock the handle into position with the two
screws 3:L.
24
ENGLISH
3.2.2 The handle's upper section
Install the handle's upper section into its lower sec-
tion in accordance with fig. 3. Use the two screws
3:I and the wing nuts 3:J.
3.3 Start control
Install the start control on the handle's upper sec-
tion in accordance with fig. 3. Use the two screws
3:H.
Secure the cable to the handle with the three
clamps 3:M.
3.4 Collector
Open the hatch and install the collector. Insert the
collector's hooks into the slots in the upper part of
the opening. See fig. 4.
4 DESCRIPTION
4.1 Controls
4.1.1 Electric socket and relieving loop
The machine must be connected via an
earth leakage circuit breaker with fault
current 30 mA. There is otherwise a
risk of fatal electric shocks.
The connection cable is connected to the ma-
chine's electric socket (3:N). The cable must then
be secured in the relieving loop (3:K) before it
leaves the machine.
4.1.2 Start and stop control
Start:
1. Press in and hold the button (3:P)
2. Squeeze the handle (3:O).
3. Release the button (3:P).
Stop:
1. Release the handle (3:O).