Inhaltsverzeichnis
Werbung
GB
This is possible in positions 45 degrees left, 0 and 45 degrees right.
D
Ensure that the lock is always tightened; if not, the sawing angle can change
during sawing.
NL
Slanted sawing II
Fig. 16+17
F
The rotating table remains in its original position (0 degrees) but the sawing surface
changes, the saw lowers slanted. Here too the starting position is: saw head as high as
possible (and rotating table set to 0 degrees, if not done yet)
E
•
Loosen the locking handle (36) to allow turning the whole saw head, the circular saw
is then not vertical any more. Handle (36) is on the back of the machine.
•
Turn the saw head to the desired position (in relation to the work piece)
P
•
Tighten the lock handle again
•
Now saw through the work piece in one time.
I
Double slanted sawing
This means that both the rotating table as the surface of the circular saw are set slanted.
•
Here too, start with the saw head up. Set the rotating table in the desired position; set
S
the surface of the circular saw in the desired position. Ensure that both settings are
locked firmly.
FIN
•
Saw through the work piece in one go here too.
6. TABLE SAWING SETTINGS
N
Safety precautions
Protective cap
DK
Fig.18
The protective cap (37) must always be used. You can connect this to dust vacuuming. It
protects you from undesired contact with the saw (which is also sharp when stopped !)
and projectile splinters and dust.
Cavity blade
The cavity blade (38) ensures that work pieces remain free of the saw. The cavity blade
should also be assembled in line with the saw blade.
Stick (39)
Fig. 19
The illustration shows how this component is used. The saw allows you to easily make
one from an old plank. Sticks ensure that your hands never need to go near the running
saw. If you do not use the stick, hang it on the pin (40).
Setting of the table sawing settings
Fig. 20-27
•
Switch power off
•
Unplug plug from contact
20
Dele
Fig.1
1.
Savbord
2.
Lås til vinkelindstilling
3.
Sidepaneler
4.
Nødstop
5.
Sammenklappeligt understel
Bordsav
Fig.1
8.
Håndhjul til dybdeindstilling
9.
Spaltekniv
10. Beskyttelsesskærm
11. Fremføringsstok
12. Parallelanslag
13. Geringsanslag
Afkorter
Fig.1
14. Savgreb
15. Drejebord
16. Materialeanslag
17. Spånfanger
18. Låsestift
19. Bevægelig beskyttelsesskærm
2. SIKKERHEDSFORSKRIFTER
Symbolforklaring
Læs anvisningerne
Overholder gældende europæiske standarder på sikkerhedsområdet
Fare for personskader eller materiel skade, hvis anvisningerne i denne
brugsanvisning ikke overholdes.
Fare for elektrisk stød
Hold hænder og fødder på afstand af saven, når denne kører.
Ferm
Ferm
GB
D
NL
F
E
P
N
DK
FIN
N
DK
133
Werbung
Inhaltsverzeichnis
