Clamps For Separatory Funnel - Heidolph Unimax 2010 Bedienungsanleitung

Assembly
▪ 25 to 100 ml clamps feature one
threaded bolt.
▪ 250 - 1000 ml clamps feature four
threaded bolts.
➜ Remove nuts and washers from clamp
bolts.
➜ Plug clamp in rack hole.
➜ Secure with washer.
➜ Tighten nuts with box-end spanner.
➜ Ensure all screws have been pulled
tight.
The only restriction is to arrange clamps in
a manner avoiding direct contact between
each other; moreover, flasks should not
protrude over the edge of the shaker
plate.
➜ Locate perforated platform with clamps
installed on shaker plate.
➜ Make sure, crimped edge is plugged
over shaker plate, thus positively
locking both parts with each other.

Clamps for separatory funnel

Perforated platform and separatory funnel clamp safely hold size 250 ml to 2000 ml
separating funnels on the shaker plate.
The perforated platform accepts the following number of separatory funnel clamps:
▪
4 ea. 250 ml
▪ 3 ea. 500 ml
▪ 3 ea. 1000 ml
▪ 2 ea. 2000 ml
A mix of various sizes may be used either.
Lightly tilt Erlenmeyer flasks to fit them under the clamp.
Washers
Nuts
Washers
Nuts
Crimped edge
18
Clamp bolts
Clamp bolts