Parkside PDTS 6.3 A1 Bedienungs- Und Sicherheitshinweise Seite 24

Safety instructions for pneumatic tools
and exchange of accessories on
the pneumatic angle grinder and
before all work near the machine.
If this is not the case, there may
be grievous injury as a result.
The pneumatic angle grinder
† z
should be configured, set, and
used exclusively by correspond-
ingly qualified and trained operat-
ing personnel.
This machine may not be altered.
† z
Alterations may compromise the
effectiveness of the safety
measures and increase the risks
for the operating personnel.
The safety instructions may not
† z
become lost – give these to the
operating personnel.
Never use damaged pneumatic
† z
angle grinders.
The pneumatic angle grinder
† z
must be inspected regularly for
the clear legibility of all rated
values and labels as demanded
under this section of ISO 11148.
If necessary, the employer/user
must contact the manufacturer for
replacement labels.
HAZARDS FROM FLYING PARTS
A fracturing workpiece, acces-
† z
sory, or machine tool can eject
parts at high speed.
Impact resistant eye protection
† z
must be worn when the pneumatic
24 GB/IE/NI
angle grinder is being operated.
The degree of this requisite protec-
tion should be rated separately for
every single use.
Ensure that the workpiece is fixed
† z
securely in place.
Ensure that the parting disc is
† z
clamped securely to the pneumatic
angle grinder.
Check that the parting disc's
† z
maximum operating speed
(in rpm) is equal to or greater
than the spindle's rated speed.
Brushes should not be fitted to
machines when their speeds are
greater than the maximum values
approved for brushes.
Make sure that the protective
† z
cowl is fitted, is in good working
condition, has been secured
properly, and is inspected at
regular intervals.
Check regularly that the pneu-
† z
matic angle grinder's speed is not
greater than that specified on the
machine. These speed tests must be
conducted without attached parting
disc and in accordance with the
manufacturer's instructions.
Check that the clamping flanges
† z
are used in accordance with the
manufacturer's specifications and
that they are plane and in good
working condition, e.g. uncracked
and unfractured.