Parkside PDTS 6.3 A1 Bedienungs- Und Sicherheitshinweise Seite 27

Before use, first inspect the
† z
abrasive. Do not use parting discs
that may have been dropped or
that exhibit spalling, cracks, or
other defects.
Make sure that before use the
† z
parting disc has been secured
properly and tightened ade-
quately. The pneumatic angle
grinder must be operated for at
least one minute at idle speed in
a safe position. The machine must
be switched OFF immediately
there is considerable vibrations
or other damage, and their cause
identified.
The spindle's measurements and
† z
other key data must be exam-
ined if there is to be no contact
between the end of the spindle
and the base of openings for
straight and flaring cup wheels or
threaded grinding rods designed
for mounting on machine spindles.
In the case of parting discs
† z
supplied with or designed for
use with adapters or adapter
bushings, the user must ensure
that the adapter or the adapter
bushing does not contact the face
side of the clamping flange and
that the clamping force generates
enough rotational drive to
prevent the parting disc from
slipping.
Safety instructions for pneumatic tools
If clamping flanges are provided
† z
for a range of parting disc types
and sizes, always fit that clamp-
ing flange matching the parting
disc used.
Before and after using the machine
† z
tool, avoid direct contact: it may
still be hot or have sharp edges.
The parting disc must be stored
† z
and handled in accordance with
the manufacturer's instructions.
HAZARDS AT THE WORKPLACE
Slipping, tripping, and falling are
† z
the predominant causes of injuries
at work. Take note of surfaces that
have become slippery through
the use of the machine and of
tripping hazards posed by the air
or hydraulic hose.
Proceed carefully in unfamiliar
† z
environments. There may be hid-
den dangers in the form of electric
or other supply cables.
The pneumatic angle grinder is
† z
not designed for use in potentially
explosive atmospheres and is not
insulated against contact with
electrical power sources.
Make sure that there are no
† z
electrical lines, gas piping, etc.,
that may pose a hazard in the
event of damage caused by the
machine in use.
GB/IE/NI 27