Herunterladen Inhalt Inhalt Diese Seite drucken

Hazards During Operation - Parkside PDTS 6.3 A1 Bedienungs- Und Sicherheitshinweise

Druckluft-trennschleifer
Vorschau ausblenden Andere Handbücher für PDTS 6.3 A1:
Inhaltsverzeichnis

Werbung

Check that there is no damage or
z
wear on the spindle and spindle
thread.
Check that there can be no
z
hazards posed by sparks and
debris generated during use.
The pneumatic angle grinder
z
must be disconnected from its
power supply before maintenance
and before the parting disc is
replaced.
TRAPPING HAZARDS
There is a risk of strangulation, scalp-
ing, and/or other cutting injury when
loose clothing, jewellery, necklaces,
hair, or gloves are not kept away
from the machine and its accessories.
HAZARDS DURING
OPERATION
Avoid contact with the rotating
z
spindle and attached parting disc
to prevent cutting injuries to hands
and other parts of the body.
Using the machine may expose
z
the operating personnel's hands
to hazards such as e.g. cuts,
scrapes, and heat. Wear suitable
gloves to protect the hands.
The operating and the mainte-
z
nance personnel must be
physically able to handle the
machine's position, size, mass,
and power output.
Safety instructions for pneumatic tools
Hold the machine correctly:
z
Be prepared to counteract the
usual or sudden movements –
keep both hands ready.
Make sure that your body is
z
balanced and that you are
standing on a stable surface.
Activate a startup or shutdown
z
control device in the event of
power outage.
Use only those lubricants recom-
z
mended by the manufacturer.
Goggles must be worn; gloves
z
and protective clothing are
recommended.
A hard hat must be worn for
z
overhead work.
Specify the runout time when
z
this is longer than 5 s; it is
recommended urgently to place
the pneumatic angle grinder in a
protected place.
For abrasive cutting work, the
z
workpiece must be supported in
such a manner that the parting slit
maintains a constant or increasing
width during the whole work.
If the parting disc jams in a
z
parting slit, the pneumatic angle
grinder must be switched OFF and
the parting disc loosened. Before
resuming operation, check that
the parting disc has been secured
properly and is not damaged.
GB/IE/NI
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis