Authorized Personnel; Operator's Obligations; User's Obligations; Additional Requirements Regarding Qualification - Optimum optimill MH25V Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y

the milling machine and other property and

the functionality of the milling machine may be compromised.

1.6.2 Authorized personnel

WARNING!
Inappropriate operation and maintenance of the machine constitutes a danger for
personnel, property and the environment.
Only authorized personnel may operate the machine!
Authorized operating and maintenance personnel are specialists instructed and trained by the
operator and the manufacturer.

1.6.3 Operator's obligations

The operator must instruct personnel at least once a year in

all safety regulations relevant to the machine,

its operation and

generally accepted engineering standards.
The operator must also

check the personnel's knowledge level,

document the training/instruction,

have attendance at the training/instruction confirmed by signature and

check whether personnel is working in a manner that shows awareness of safety and risks.

Define and document the machine inspection deadlines in accordance with section 3 of the
Factory Safety Order and perform an operational risk analysis in accordance with section 6
of the Safety at Work Act.

1.6.4 User's obligations

The user must

have read and understood the operating instructions,

be familiar with all safety devices and regulations and

be able to operate the machine.

1.6.5 Additional requirements regarding qualification

The following additional requirements apply for work on electrical components or equipment:

They must only be performed by a qualified electrician or person working under the instruc-
tions and supervision of a qualified electrician.
Before starting work on electrical parts or operating agents, the following actions must be taken
in the order given:

disconnect all poles,

secure against restarting,

check that there is no voltage.
1.7

User positions

The user position is in front of the milling machine.
GB MH25V
Page 52 Original operating instructions Version 1.0.1 dated 2015-12-17