Personnel Qualification; Target Group - Optimum optimill MH25V Betriebsanleitung

WARNING!
The milling machine may only be used with fully functional safety devices.
Disconnect the milling machine immediately, whenever you detect a failure in the safety
devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices. This is your responsibility as the operator!

"Safety devices" on page 53
1.6

Personnel qualification

1.6.1 Target group

This manual is addressed to

operators,

users and

maintenance personnel.
Consequently, the warning notes refer both to the use of the milling machine and to its mainte-
nance.
WARNING!
Always isolate the milling machine from the electrical power supply. This will prevent it from
being used by unauthorized persons. The qualifications of the personnel for the different tasks
are mentioned below:
User
The user must have been instructed by the operator about the assigned tasks and possible
risks in case of improper behaviour. The user may only carry out tasks that exceed normal
operation if this is stated in these instructions and the operator has explicitly entrusted him with
the task.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers. Qualified electricians have been specially
trained for the working environment, in which they are working and know the relevant standards
and regulations.
Qualified personnel
Because of their specialist training, knowledge and experience as well as their understanding of
the relevant regulations, qualified personnel is capable of carrying out tasks assigned to them
and recognise and avoid potential hazards without supervision.
Instructed person
An instructed persons has been instructed by the operator regarding the assigned tasks and
the possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,
Version 1.0.1 dated 2015-12-17 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
MH25V GB
Page 51