Inserting The Tool; Quick-Change Clamping System; Removal - Optimum optimill MH25V Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
4.8

Inserting the tool

4.8.1 Quick-change clamping system

The milling head is equipped with a collet chuck for tigh-
tening with pull stud BT30x45 °.

Tightening pull stud into the taper.

Clean the seat in the milling spindle.

Clean the cone of your tool.

Place the tool into the milling spindle. Put a 10mm
Allen key in the mounting hole and turn it clockwise
to open the collet chuck.

4.8.2 Removal


Hold the tool.

Put a 10mm Allen key in the mounting hole and turn
it clockwise to open the collet chuck.
GB MH25V
Page 68
Img.4-1:
Img.4-2:
Original operating instructions
43
23
45°
pull stud
MAS BT30
Version 1.0.1 dated 2015-12-17