Gaspardo ALITALIA Gebrauch Und Wartung Seite 63

There are various types of wheels for a wide range of applications,
in three different product families (Fig. 24):
red:
5 elements, 8 chambers per wheel, (mod. G1000) (A);
green: 5 elements, 16 chambers per wheel, (mod. N500) (B);
yellow: 5 elements, 32 chambers per wheel, (fi ne seeds dosing
roller) (mod. F25-125) (C).
As described above, remove the round belt of the agitator,
then screw the handwheel to the side of the dosing roller (Fig. 25)
and proceed when the machine is completely empty.
Once the fastening knob of the dosing roller has been released,
it remains connected to the doser casing, in order to safeguard
against it being accidentally lost.
Slide the dosing roller out sideways (Fig. 26) and remove it from
the doser (Fig. 27).
To re-assemble, follow the steps in reverse order.
During the assembly phase, rotate the dosing roller in the driving
direction and push it into the doser (Fig. 28), until the drive pin
engages in the gearbox (Fig. 29).
To start up the agitator, fi rst fi t the belt on the small agitator disc,
then apply pressure to the lower edge of the dosing roller and, on
the opposite side, rotate the dosing roller on the handwheel, in the
driving direction until the belt comes off (Fg. 30).
fi g. 25
fi g. 28
cod. G19503391
USE AND MAINTENANCE
fi g. 24
fi g. 26
fi g. 29

A
C
fi g. 27
fi g. 30
ENGLISH
B
EN - 63