1.2 Combination possibilities
This prosthetic component is part of the Ottobock modular system. As a res
ult of its design, it may be combined with other prosthetic components of the
modular system. You can find possible restrictions in this section. Contact
the manufacturer with questions.
2 Application
2.1 Indications for use
The product is to be used solely for lower limb prosthetic fittings.
2.2 Area of application
The product is recommended for mobility grade 1 (indoor walk
er) and mobility grade 2 (restricted outdoor walker).
m°
kg
Maximum body weight according to stiffness [kg]
Size [cm]
Stiffness 1
Stiffness 2
Stiffness 3
Stiffness 4
Stiffness 5
Stiffness 6
2.3 Environmental conditions
Allowable environmental conditions
Temperature range for use: -10 °C to +60 °C
Relative humidity: no restrictions
Chemicals/moisture: fresh water, salt water, chlorine water, soapsuds, sweat, urine
Solids: dust, sand, highly hygroscopic particles (e. g. talcum)
Clean the product after contact with humidity/chemicals/solids, in order to
avoid increased wear and damage (see Page 18).
2.4 Service Life
This product has been tested by the manufacturer with 2 million load cycles
according to ISO 22675. Depending on the patient's activity level, this cor
responds to a service life of 2 to 3 years.
22
23
24
55
55
75
75
100
100
–
125
–
150
–
25
26
27
–
75
100
125
150
–
175
28
29
30
–
–
100
125
150
175
Ottobock | 13