Ottobock 1C11 Terion K2 Gebrauchsanweisung Seite 18

5.2 Optional: Installing the foam cover
The connection cap serves as a detachable connection between the foam
cover and footshell, and snaps precisely into the proximal brim of the foot­
shell.
Required materials: 634A58 isopropyl alcohol, 636N9 contact adhesive
>
or 636W17 plastic adhesive
1) Cut the foam cover to length according to the patient's measurements,
allowing for distal compression of about 1 cm for transtibial foam covers
and of about 4 cm for transfemoral foam covers.
2) Pull the foam cover over the prosthesis.
3) Join the connection cap to the footshell and mount the prosthetic foot.
4) Mark the outer contours of the connection cap on the distal face of the
foam cover.
5) Dismount the prosthetic foot and remove the connection cap from the
footshell.
6) Clean the connection cap with isopropyl alcohol.
7) Glue the connection cap to the face of the foam cover as marked and
allow the glued joint to set (approx. 10 minutes).
8) Mount the prosthetic foot and adapt the exterior cosmetic cover shape.
Take into account compression due to cosmetic stockings or SuperSkin.
6 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
8 Disposal
This product may not be disposed of with regular domestic waste in all juris­
dictions. Disposal that is not in accordance with the regulations of the coun­
try where the product is used may have a detrimental impact on health and
the environment. Please observe the information provided by the responsible
authorities in the country of use regarding return, collection and disposal
procedures.
18 | Ottobock