Lincoln Quicklub series Benutzerinformation Seite 21

Owner Manual
Operating Instructions
Safety instructions ........................................................ 2
Progressive metering devices model SSV .................. 4
Suitable lubricants ......................................................... 4
Progressive metering devices - General .................. 4
Lubricant distribution within the metering device ........... 5
Monitoring of the operation ............................................. 7
System-dependent monitoring ................................. 7
Visual monitoring ..................................................... 7
Electrical monitoring ................................................. 8
Dertermining the lubricant output by
combining outlets .......................................................... 8
Tube fittings, screw-type (main metering device
and secondary metering devices) ............................ 8
Tube fittings, push -in type (main metering device) .. 9
Further information can be found in the following manuals:
Technical Description Quicklub Pump 203
Technical Description for ''Electronic Control Units" of pump 203 :
Printed-Circuit Board 236-13862-1 - Model V10 - V13*
Printed-Circuit Board 236-13857-1 - Model H *
Printed-Circuit Board 236-13870-1 - Models M 00-M 15*
Printed-Circuit Board 236-13870-1 - Models M 16-M 23*
Installation Instructions
Parts Catalog
* The model designation of the printed-circuit board is part of the pump model designation mentioned on the pump nameplate.
Example: B. : P 203 - 2XN - 1K6 - 24 -1A1.10 - V10
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Table of Contents
Page
Tube fittings, screw-type
(secondary metering devices) ................................ 10
Single lubricant output ............................................ 10
Double or multiple lubricant output ......................... 10
Tube fittings, Screw-type ............................................. 11
Tube fittings, push-in type ............................................ 11
Metering device ....................................................... 11
Connecting the lubricant feed lines
and high-pressure hoses ...................................... 12
Protection cap for plug-type fittings ......................... 12
Pressure plastic tubes and
high-pressure hoses ................................................... 13
Troubleshooting .......................................................... 14
Technical data ............................................................. 16
Tightening Torques ...................................................... 16
List of Lubricants ........................................................ 17
2.2A-20001-F06
Page
Page 3/19