Technical Data; Standards And Operating Conditions; Conformities/Approvals; Protection Of Persons And Device Protection - Lenze i550 Montage- Und Einschaltanleitung

Technical data

EMC data

Technical data

Standards and operating conditions

Conformities/approvals

Conformity
CE
EAC
RoHS
Approval
UL

Protection of persons and device protection

Degree of protection
IP20
Open type
Insulation resistance
Overvoltage category III
Overvoltage category II
Isolation of control circuits
Safe mains isolation via double/reinforced
insulation
Leakage current
> 3.5 mA AC, > 10 mA DC
Starting current
≤ 3 x rated mains current
Protective measures against
Short circuit
Earth fault
Overtemperature of motor
Overvoltage
Motor stalling
EMC data
Noise emission
Category C1
Category C2
Category C3
Noise immunity
Fulfills requirements according to
Operation on public supply systems
Take measures to limit the expected radio
interference:
< 1 kW: With mains choke
> 1 kW for mains current ≤ 16 A: Without
additional measures
Mains current > 16 A: with mains choke
or mains filter, with dimensioning for
rated power.
188
2014/35/EU Low-Voltage Directive
2014/30/EU EMC Directive (reference: CE-typical drive system)
TR CU 004/2011 Eurasian conformity: safety of low voltage equipment
Eurasian conformity: electromagnetic compatibility of
TR CU 020/2011
technical means
Restrictions on the use of certain hazardous substances in
2011/65/EU
electrical and electronic devices
for USA and Canada (requirements of the CSA 22.2 No.
UL 61800-5-1 274)
File No. E132659
Data applies for operationally ready mounted state and not
EN 60529
in wire range of terminals
UL 50 Protection against accidental contact only
Only in UL-approved systems
EN 61800-5-1 0 ... 2000 m amsl
EN 61800-5-1 over 2000 m amsl
EN 61800-5-1
EN 61800-5-1 Please observe regulations and safety instructions!
Earth-fault protected depending on operating status
PTC or thermal contact, I²xt monitoring
EN 61800-3 See rated data
EN 61800-3 See rated data
EN 61800-3 See rated data
EN 61800-3
The machine or system manufacturer is responsible for
compliance with the requirements for the machine/system!
EN 61000-3-2
EN 61000-3-12